Battery
Battery remova
Remove the rubber pad (1) of pedal.
Remove the clamp bolt and clamp of battery.
irst remove the negative wire and then
remove the positive wire.
Take the battery (5) from the battery container.
Warning！
The tools for removing the positive electrode should not
contact the flame, otherwise it will be very dangerous that the
damaged battery will cause fire.
Install the battery following the opposite sequence.
Warning！
Do not disconnect the battery during the adjustment
of motorcycle, otherwise inner component of the motorcycle may be damaged.
Charging state（closed circuit voltage）
inspection
Open the cover of battery container. 。
First remove the negative wire and then
remove the positive wire.
Take out the battery.
Measure the voltage between battery terminals.
Full charge：13.1V
Under charge：12.3V
* Note
Charge state examination must use a voltmeter operation.
Charge
Connection method：Connect the battery charger positive
pole and battery positive pole together.
Connect the battery charger negative pole
and battery negative pole together.
伏特表：voltmeter
To Next Page
Loading...
Need help?
General
