Remove the front left/right muffler component (4, 5).
Tools:
Direction handle welding component fixing bolt wrench.
Fixing nuts wrench.
Special tools of the Bearing steel bowl removing.
* Note:
Wipe the openings of the body protection plate with rage.
Remove the high and low bearing steel bowl with special tools of bearing bowl removing.
7.5.3 Installation
Smear the bottom bearing steel bowl with lubricating oil and confirm the amount of the steel ball（22）.
When installing the steering rod, the direction handle shall not be turned (in order to prevent the steel ball from
falling).
Supporting the direction handle, smear the top bearing steel bowl with lubricating oil and confirm the amount of
the steel ball (22).
Smear the top seat ring with lubricating oil.
Turn the direction handle in left and right to make the steel ball contact close with each other.
Tools:
Fixing nuts wrench.
Turn the front fork in left and right to confirm it’s smooth and unloosing.
Steps:
Install the front left/right muffler component.
Install the direction handle.
Install the body protection plate.
Install the front wheel.
*Note: referring to the assembly and disassembly view of QJ50T-21T front fork on page 88.
Rear wheel/rear suspension
To Next Page
Loading...
