1 rear low fender 2 rear fender wing lapel 3 rear low fender 4 rear fender 5 rear reflector component
6 tap rear over 7 tap front cover 8 speedometer visor 9 pad component 10 helmet bucket 11
decoration plate of the front big cover panel 12 front big cover panel 13 front base plate 14 left
connection plate 15 right connection plate 16 low connection plate 17 foot protecting plate 18
storage battery box cover 19 frame number plate 20 rear pedal component 21 pedal left protection
cover 22 pedal 23 pad lock 24 spark plug cover plate 25 connection plate of left and right protection
plate 26 right protection plate 27 left protection plate 29 rear connection plate of left and right
protection plate 30 front fender 31 side reflector component 32 license light component 33 front
light 34taillight 35 decoration plate of right foot protection plate 36 right rear view mirror 36 left
rear view mirror 38 meter
6. Body cover
Remove the body in the following sequence
Handle cover1→left/right rear view mirror→handle cover2→foot protection plate→
protection plate in the base plate→front big cover→front light
↓
→pad assembly→left/right protection stripe→low connection plate→front fender→
rear shelf assembly→decoration plate of the protection plate
↓
→left/right pedal cover→decoration plate of the left/right protection plate →
left/right protection plate→perspective hole cover→connection plate of the left/right
protection plate
↓
→storage battery cover→pedal→taillight→rear fender→rear low fender
*Note:
The body cover should not be damaged when being assembled and disassembled.
The hoop-claw part of the body should not be damaged when being assembled and disassembled.
To Next Page
Loading...
Need help?
General
