1. Preparations for measurement
8
6) Install the desiccant tube onto the reagent bottle holder.
7) Place the reagent bottle in the bottle holder. If the outside diameter of
reagent bottle does not match the holder, use the bottle holder and bottle
stand as shown below.
8) Connect the tube for drain and injection to the Plug for titration flask as shown
below respectively.
Plug for
titration flask
To rubber ball for
reagent discharge
Bottle stand
Bottle holder
9) Insert the Plug for titration flask carefully into the titration cell. At this point,
apply a small amount of KF grease on slide contact area.
To Next Page
Loading...
Need help?
General
