KEM MKC-710 - Beep

6. Setup
MKC-710 81
Beep 6-7.
Select the beep at the end of measurement.
Select “7．Beep” with [↑][↓] and press [ENTER].
[Beep]
Select the beep.
x Off : Turns off the beep. Turns off the beep during measurement as well.
x Set : Sets up the beep. Select from types below
[Type]
Select the beep from the five (5) types below.
Move the cursor with [←] [→] keys to the type you wish to use, and press [ENTER].
x Type1 ：Beep sound lasts for about two seconds: “pi, pea-pea-pea-pea”
x Type 2 ：Beep sound lasts for about four seconds: “pi-pi-pi-pi-pi-pi”
x Type 3 ：Beep sound lasts for about ten seconds: “pi, pea-pea-pea-pea”
x Type 4 ：Beep sound lasts for about one second: “pi-pi-pi-pi-pi-pi”
x Type 5 ：Beep sound lasts for about one second: “pi, pea-pea-pea”