1. Preparations for measurement
10
5) Connect the tubes, one for draining to waste bottle and the other for injection to the two
bottles respectively.
6) Connect the drain tube to Cell and injection tube to the plug for titration flask.
7) Connect the drain tube to waste bottle and the drain tube to Cell to magnetic stirrer back
side pump.
8) Connect the silicone tube connected 2) to SOLVENT port on the rear panel of magnetic
stirrer.
9) Attach a filter to INTAKE port on the rear panel of magnetic stirrer.
Please attach a filter to INTAKE by all means. In other words it might break down
in the electromagnetic valve in the flow when absorb dust.
Drain tube to waste
bottle
To Next Page
Loading...
