5. Function Tools
MKC-710 57
[Lot]
You can No. a Lot with characters up to 10 letters.
[Method No.]
Sets up the method No. you wish to use in measurement. Once set, the method
name will appear in “Method Name.”
x 01～20
[Blank]
Enter Blank value of sample.
x 0～99999.9999μg
[Wt1/Wt2]
Enter tare weight+sample weight in Wt1 and tare weight after injecting the sample
in Wt2. If a balance is connected, you can follow its instructions. Absolute values are
entered with a balance connected.
x 0～9999.9999g
[FA]
Factor value that is coefficient related to the results.
x 0～99999.9999
<Sample setting after titration has started>
If you press [SAMPLE] key during titration, the following display will appear and you
can enter sample setting. Enter items you wish to set up. Then move the cursor to
[Exit] and press [ENTER] key.
Sample No. and Method No. cannot be changed once measurement as started.
To Next Page
Loading...
Need help?
General
