3 Remote Interface Reference
Status Reporting Commands
122 E364xA User’s and Service Guide
*OPC
Set the “Operation Complete” bit (bit 0) of the Standard
Event register after the command is executed.
*OPC?
Return 1 to the output buffer after the command is
executed.
*PSC {0|1}
(Power- on status clear.) This command clears the Status
Byte and the Standard Event register enable masks when
power is turned on (*PSC 1). When *PSC 0 is in effect, the
Status Byte and Standard Event register enable masks are
not cleared when power is turned on.
*PSC?
Query the power- on status clear setting. The returned
parameter is 0 (*PSC 0) or 1 (*PSC 1).
*SRE <enable value>
Enable bits in the Status Byte enable register.
*SRE?
Query the Status Byte enable register. The power supply
returns a decimal value which corresponds to the
binary- weighted sum of all bits set in the enable register.
*STB?
Query the Status Byte summary register. The *STB?
command is similar to a serial poll but it is processed like
any other instrument command. The *STB? command
returns the same result as a serial poll but the Request
Service bit (bit 6) is not cleared if a serial poll has occurred.
To Next Page
Loading...
