8 Service and Maintenance
Operation Verification and Performance Tests
192 E364xA User’s and Service Guide
Operation Verification and Performance Tests
Operation verification tests
To ensure that the power supply is operating properly,
without testing all specified parameters, perform the
following test procedures:
• Perform the power- on self- test and follow the procedures
for
“Checking the output” on page 10. (Refer to
“Self- test” on page 53 for more information.)
• Perform the “Voltage programming and readback
accuracy” and “Current programming and readback
accuracy” tests.
Performance tests
The following sections provide test procedures for verifying
the power supply’s compliance with the specifications listed
in
“Electrical Specifications” on page 172. All of the
performance test specifications and calculated measurement
uncertainties are entered in the appropriate performance
test record card for your specific model. You can record the
actual measured values in the column provided in this card.
If you use equipment other than that recommended in
Table 8- 4, you must recalculate the measurement
uncertainties for the actual equipment used.
To Next Page
Loading...
Need help?
General
