2 Operation and Features
View Menu Operation
40 E364xA User’s and Service Guide
View Menu Operation
From the View menu, you can read the errors, firmware
revision, and calibration string. In addition, you can change
the front panel display mode to V- V display, I- I display, or
V- I display as desired. With this V- V or I- I display mode
setting, you can see voltages or currents on the output1 and
the output2, simultaneously.
• After the display mode is set to V- V or I- I, you cannot
change the limit values. If you attempt to change the limit
values by turning the knob or pressing one of the
following keys —
, , , , or , the
front panel display will automatically return to the normal
display to allow you to change the
limit values.
• After the display mode is set to V-V or I- I, all the
annunciators remain unchanged.
• To exit the view menu without any changes, press
until NO CHANGE is displayed, or select EXIT by turning the
knob and press
.
Changing the display mode
1 Enter the View menu.
DISPLAY
If ERRORS appears when you enter the view menu, one or
more command syntax or hardware errors have been
detected. Then turn the knob until “DISPLAY” is displayed.
2 Select the display mode you want to display.
V-I DISPLAY
Select one of the following display modes by turning the
knob — V-V DISPLAY, I-I DISPLAY, or V-I DISPLAY.
3 Save the change and exit the menu.
To Next Page
Loading...
Need help?
General
