5 Application Programs
Overview
144 E364xA User’s and Service Guide
Overview
The application programs in this chapter help you to develop
programs for your own application.
Chapter 3, “Remote
Interface Reference” lists the syntax for the SCPI commands
available to program the power supply.
The examples in this chapter have been tested on a PC
running Windows 3.1, Windows 95, or Windows NT 4.0. The
examples are written for use over the GPIB (IEEE- 488) or
RS- 232 interface. However, the examples for use over the
RS- 232 interface do not work with Windows 3.1.
These examples require a Virtual Instrument Software
Architecture (VISA) driver for use with your GPIB interface
card in your PC. You should have the visa.dll for Windows
3.1 or visa32.dll for Windows 95 or Windows NT 4.0 in your
c:\windows\system directory for the examples in this
chapter to run properly. The examples step through voltages
and make corresponding current readings to characterize a
power diode.
To Next Page
Loading...
Need help?
General
