E4990A Help
156
This causes the multi-peak search to be executed based on the
definitions of the currently set lower limit for the peak excursion value
and newly set peak polarity.
6. Press Search Multipeak to move the marker to the peak.
When the data format is Smith chart or polar format,
execute the search for the main response value of the two marker
response values.
Searching for the Target Value (Target search)
The target search is a function that searches for a target that matches the
pre-defined target value and transition type(s) (positive, negative, or both
positive and negative) and then moves the marker to that target.
Target and Transition Types
A target is a point that has a specific measured value on the trace. Targets
can be divided into the two groups shown below depending on their
transition type.
Transition type:
Positive (Positive)
When the value of the target is larger than the
measured value that immediately precedes it (on
the left side).
Transition type:
Negative (Negative)
When the value of the target is smaller than the
measured value that immediately precedes it (on
the left side).
Executing a Target Search
To Next Page
Loading...
