Keysight E4990A - Page 187

Measurement
177
3. Click Edit Limit Line to display the limit table.
4. Using the limit table, create/edit a segment. Initially, no segments
are entered in the limit table. At the same time, the Edit Limit Line
menu used to create/edit the limit table is displayed.
5. Click Add to add a segment to the limit table and then specify the
segment parameter values shown below.
Segment
Parameter
Description
Type
Select the type of segment from the
following:
OFF
Segment not used for the limit test.
MIN
Segment at which the minimum is
specified.
MAX
Segment at which the maximum is
specified.
Begin Stimulus
Specify starting point for stimulus value on
the limit line.
End Stimulus
Specify ending point for stimulus value on the
limit line.
Begin Response
Specify starting point for response value on
the limit line.