Keysight E4990A - Page 252

E4990A Help
242
to LAN remote control
system.
USB
System to control the
E4990A and other devices
connected via USB from the
external controller.
For more information, refer
to USB Remote Control
System.
E4990A
None (Internal
Connection)
Not supported
GPIB (system
controller mode)
Not supported
GPIB remote control system
•
About GPIB
• System Configuration
Other topics about Overview
About GPIB
GPIB (General Purpose Interface Bus) is an interface standard for
connecting computers and peripherals, which supports the following
international standards: IEEE 488.1, IEC-625, IEEE 488.2, and JIS-C1901.
The GPIB interface allows you to control the Agilent E4990A from an
external computer. The computer sends commands and instructions to the
E4990A and receives data sent from the E4990A via GPIB.
System Configuration
Use GPIB cables to connect between the E4990A, the external controller
(computer), and peripherals. The following figure shows the overview of
the system configuration of the GPIB remote control system.
Configuration of the GPIB remote control system