Programming
311
T1
Response time of /PASS FAIL write strobe
1 μs
T2
Pulse width of /PASS FAIL write strobe 1 μs
When the average trigger function is activated, the fail and
write strobe signals are output at the time that the average test
result shows "failed" on a certain channel.
Timing Chart of /INPUT1 and /OUTPUT1, /OUTPUT2
Minimum
value
Maximum
value
T1
Pulse width of /INPUT1 1 μs -
T3
Response time of /OUTPUT1,
/OUTPUT2
0.2 μs 0.4 μs
Electrical Characteristics
•
Input Signal
• Output Signal
• Power Supply (+5V)
Other topics about Communication with External Devices
Input Signal
All input signals are TTL compatible.
Maximum rate input voltage
-0.5 V to 5.5 V
To Next Page
Loading...
