Keysight E4990A - Page 330

E4990A Help
320
because of a new message received
before the completion of data output.
3
Instrument
Dependent
Error
Set to "1" when an error has occurred and
the error is not a command, query, or
execution error.
4
Execution
Error
1. Set to "1" when any parameter in an
SCPI command exceeds its input range or
is inconsistent with the E4990A's
capabilities.
2. Set to "1" when an SCPI command
cannot be properly executed due to some
condition of the E4990A.
5
Command
Error
1. Set to "1" when an IEEE 488.2 syntax
error occurs (a command sent to the
E4990A does not follow the IEEE 488.2
syntax). Possible violations include the
command parameter violating the E4990A
listening formats or being unacceptable.
2. Set to "1" when a semantic error
occurs. Possible causes include a
command containing misspellings being
sent to the E4990A or an IEEE 488.2
command not supported by the E4990A
being sent.
3.
Set to "1" when GET (Group Execution
Trigger) is input while a program message
is being received.
6 Not used Always 0
7 Power ON
Set to "1" when the E4990A is powered
ON, or when the firmware is restarted.
Issuing the *CLS command clears all bits from the standard event status
register.
Status Bit Definitions of the Operation Status Condition Register
Bit
Position
Name Description