Keysight E4990A - Page 379

Programming
369
:CALCulate<Ch>[:SELected]:FUNCtion:TYPE?
Description
This command sets/gets the type of analysis.
Variable
Parameter Selection Option
Description Analysis type
Data Type Character string type (String)
Range
"PTPeak": Specifies the analysis of the difference
between the maximum value and the minimum value
(Peak to Peak).
"STDEV": Specifies the analysis of the standard deviation.
"MEAN": Specifies the analysis of the mean value.
"MAXimum": Specifies the search for the maximum
value.
"MINimum": Specifies the search for the minimum value.
"PEAK": Specifies the search for the peak.
"APEak": Specifies the search for all peaks.
"ATARget": Specifies the search for all targets.
"SDEViation": Specifies the search for all deviations.
"RPP": Specifies the search for the difference value
between the maximum peak measurement parameter
value and the minimum negative peak measurement
parameter value.
"RPLHei": Specifies the search for the maximum value
after calculating the ripple (measurement parameter
value difference between the peak and its both side
adjacent negative peak).
"RPLLhei":Specifies the search for the maximum value
after calculating the left-side ripple (measurement
parameter value difference between the peak and its left
adjacent negative peak).
"RPLRhei":Specifies the search for the maximum value
after calculating the right-side ripple (measurement
parameter value difference between the peak and its