Keysight E4990A - Page 570

E4990A Help
560
Dim Var as String
Ana.WriteString ":SENS:ROSC:SOUR?", True
Var=Ana.ReadString
Equivalent Softkey
Displayed on the instrument status bar (at the bottom of the LCD display).
COM Command Syntax (Internal Control Only)
SCPI.SENSE(Ch).ROSCILLATOR.SOURCE
:SENS<Ch>:SEGM:DATA
Type
Command/Query
Syntax
:SENSe<Ch>:SEGMent:DATA <Value>
:SENSe<Ch>:SEGMent:DATA?
Description
This command sets/gets the list for segment sweep.
Variable
Parameter Value
Description
Segment Table Setup
Indicates the array data arranged in the following order
(for the segment sweep table); where N is the number of
segments (specified with <segm>) and n is an integer
between 1 and N.
Data = {<buf>,<stim mode>,<list OSC level
on/off>,<list bias on/off>,<list meas time o/off>,<list
average on/off>, <list segment time on/off>, <list delay
time on/off>,<segm>, <star 1>,<stop 1>,<poin>,[OSC
Level type 1],[OSC Level 1],[Bias type 1],[Bias Level
1],[meas time 1],[averaging factor 1],[segment time
1],[delay time 1], ... ,[OSC Level type N],[OSC Level
N],[Bias type N],[Bias Level N],[meas time N],[averaging
factor N],[segment time N],[delay time N] }
Each parameter in the above array data is detailed
below:
<buf>: Always specify 7.
<stim mode>: Stimulus setting mode
0: Specifies with start/stop values
1: Specifies with center/span values