Keysight E4990A - Page 608

E4990A Help
598
:SOURce:BIAS:STATe {ON|OFF|1|0}
:SOURce:BIAS:STATe?
Description
This command sets/gets the DC Bias Output State. This setting is applied
for all channels and traces. The DC bias is automatically turned off after
recall the status file.
Variable
Parameter Selection Option
Description DC bias output On/off state
Data Type Boolean type (Boolean)
Range ON|OFF|1|0
Preset Value OFF
Query Response
{1|0}<newline><^END>
Examples
Dim Var as Integer
Ana.WriteString ":SOUR:BIAS:STAT ON", True
Ana.WriteString ":SOUR:BIAS:STAT?", True
Var=Ana.ReadNumber
Related Commands
:SOUR:BIAS:MODE
Equivalent Softkey
Sweep Setup > DC Bias > DC Bias State
Sweep Setup > DC Bias State
COM Command Syntax (Internal Control Only)
SCPI.SOURCE.BIAS.STATE
:SOUR:BIAS:VOLT
Type
Command/Query
Syntax
:SOURce:BIAS:VOLTage[:LEVel][:IMMediate][:AMPLitude] <Value>
:SOURce:BIAS:VOLTage[:LEVel][:IMMediate][:AMPLitude]?