Keysight N9912A - Page 110

8- 2 Keysight N9912-90001 User’s Guide
SA (Spectrum Analyzer) Mode
8-
See Also
“External Gain” on page 8-10
“Attenuation Control” on page 8-10
“Preamplifier Control (Opt 235)” on page 8-11
“Check for Compressed Measurements” on page 8-11
“Field Strength Measurements” on page 8-12
“Tune & Listen (AM/FM)” on page 8-16
“Independent Source” on page 8-18
“Resolution Bandwidth (Res BW)” on page 8-20
“Video Bandwidth (Video BW)” on page 8-21
“Sweep Type” on page 8-21
“Sweep Acquisition” on page 8-22
“Very Long Sweep Times” on page 8-23
“Zero Span Measurements” on page 8-23
“Triggering” on page 8-25
“Single / Continuous / Restart” on page 8-27
“Points” on page 8-27
“Trace Display States” on page 8-28
“Average Type” on page 8-29
“Average Count” on page 8-29
“Detection Method” on page 8-30
“Display Line” on page 8-31
“Noise Marker” on page 8-32
“Band/Interval Power Marker” on page 8-33
“Frequency Counter at Marker” on page 8-34
“Audio Beep at Marker Power” on page 8-35
“Channel Measurements” on page 8-37
Interference Analyzer (Opt 236):
“Spectrogram Display” on page 9-2