Driving your vehicle
906
Rear Cross-Traffic Collision Warning (RCCW)
䳜 the detected vehicle moves out of
the sensing area or
䳜 when the vehicle is right behind
you
r vehicle or
䳜 when the vehicle is not approach
-
ing your vehicle or
䳜 when the other vehicle slows
down
.
䳜 When the operation condition of
the Rear Cross-Traffic Collision
Warning system is satisfied, the
warning will occur every time a
vehicle approaches the side or
rear of your stopped (0 mph vehi
-
cle speed) vehicle.
䳜 The system's warning or brake
ma
y not operate properly if the
left or right of your vehicle's rear
bumper is blocked by a vehicle or
obstacle.
䳜 T
he driver should always use
e
xtreme caution while operating
the vehicle, whether or not the
warning light on the outer side
view mirror illuminates or there is
a warning alarm.
䳜 Pl
aying the vehicle audio system
a
t high volume may prevent occu
-
pants from hearing the system's
warning sounds.
䳜 If any other warning sound such
as
seat belt warning chime is
already generated, the Rear
Cross-Traffic Collision Warning
system warning may not sound.
䳜 Drive safely even though the
vehicle is equipped with a Rear
Cross-Traffic Collision Warning
system. Do not solely rely on the
system but check your surround
-
ing when backing the vehicle up.
䳜 The driver is responsible for accu
-
rate brake control.
䳜 Always pay extreme caution while
driving. The
Rear Cross-Traffic
Collision Warning system may not
operate properly or unnecessarily
operate depending on traffic and
driving conditions.
Detecting Sensor
The rear radars are located inside
the rear bumper for detecting the
side and rear areas. Always keep the
rear bumper clean for proper opera
-
tion of the system.
To Next Page
Loading...
Need help?
General
