What to do in an emergency
227
If you have a flat tire (with Tire Mobility Kit)
10.Detach the hoses from the seal
-
ant bottle connector and from the
tire valve.
11.Return the Tire Mobility Kit to its
storag
e location in the vehicle.
Carbon monoxide
Carbon monoxide poisoning and suf
-
focation is possible if the vehicle is
left running in a poorly ventilated or
unventilated location (such as inside
a building).
Distributing the sealant
After putting sealant into the tire, it
is necessary to drive the vehicle so
that the sealant becomes evenly
distributed inside the tire.
䳜 Im
mediately drive approximately
4~6 miles (7~10 km or
, about 10
min) to evenly distribute the seal
-
ant in the tire.
Do not exceed a speed of 50 mph
(80 km/h). If possibl
e, do not fall
below a speed of 12 mph (20 km/h).
While driving, if you experience any
un
u
sual vibration, ride disturbance
or noise, reduce your speed and
drive with caution until you can
safely pull off of the side of the
road.
When you use the Tire Mobility Kit,
the tire pressure sensors and wheel
may be stained by sealant. There
-
fore, remove the tire pressure sen
-
sors and wheel stained by sealant
and have your vehicle inspected by
an authorized Kia dealer.
Checking the tire inflation pressure
After driving briefly so as to distrib
-
ute the sealant throughout the
inside of the tire, you should check
the tire inflation pressure.
1. After driving approximately 4~6
mile
s (7~10 k
m or about 10 min),
stop at a safe location.
To Next Page
Loading...
