63
4
4
Features of your vehicle Mirrors
2. Position the garage door opener
remote 1 - 3 inches (2 - 8 cm)
away from the HomeLink but
-
tons.
3. While the HomeLink indicator light
(7) is flashing orange, press and
hold the hand-held remote but
-
ton. Continue pressing the hand-
held remote button until the
HomeLink indicator light (7) light
changes from orange to green.
You ma"y now release the hand-
held remote button.
4. Wait until your garage door
comes to a complete stop,
regardless of position, before pro
-
ceeding to the next steps.
5. Press and release the HomeLink
button you are programming and
observe the indicator light.
䳜 If the indicator light remains
solid green, your device should
operate when the HomeLink
button is pressed. At this point,
if your device operates, pro
-
gramming is complete.
䳜 If the indicator light rapidly
flashes green, firmly press, hold
for two seconds and release the
HomeLink button up to three
times in a row slowly to com
-
plete the programming process.
Do not press the HomeLink but
-
ton rapidly. At this point if your
device operates, programming
is complete. If the device does
not operate, continue with step
6.
6. At the garage door opener motor,
(security gate motor, etc.) locate
the "Learn", "Smart", "Set" or
"Program" button. This can usu
-
ally be found where the hanging
antenna wire is attached to the
motor-head unit (see the device's
manual to identify this button).
The name and color of the button
may vary by manufacturer.
* A ladder and/or second person
may simplify the following
steps.
To Next Page
Loading...
