Features of your vehicle
404
Windows
(30 cm) to allow the object to be
cleared.
If the window detects the resistance
while the power window switch is
pulled up continuously, the window
will stop upward movement then
lower approximately 1 in (2.5 cm).
And if the power window switch is
pulled up continuously again within
5 seconds after the window is low
-
ered by the automatic window
reversal feature, the automatic win
-
dow reversal will not operate.
The automatic reverse feature for
the window is only active when the
"auto up" feature is used by fully
pulling up the switch. The automatic
reverse feature will not operate if
the window is raised using the half
-
way position on the power window
switch.
Always check for obstructions
before raising any window to avoid
injuries or vehicle damage. If an
object less than 0.16 in (4 mm) in
diameter is caught between the
window glass and the upper window
channel, the automatic reverse win
-
dow may not detect the resistance
and will not stop and reverse direc
-
tion.
The automatic reverse feature
doesn't activate while resetting the
power window system. Make sure
body parts or other objects are
safely out of the way before closing
the windows to avoid injuries.
Do not install any accessories in the
vehicle that extend into the open
window area. Such objects could
prevent the automatic reverse fea
-
ture from functioning.
Power window lock button
The driver can disable the power
window switches on the rear pas
-
sengers' doors by pressing the
power window lock button to the
lock position (pressed).
To Next Page
Loading...
Need help?
General
