Features of your vehicle
684
Mirrors
Information
HomeLink and the HomeLink House
logo are registered trademarks of
Gentex Corporation.
The myQ logo is a registered trade
-
mark of The Chamberlain Group, Inc
FCC (USA) and ISED (Canada)
This device complies with FCC rules
part 15 and Innovation, Science, and
Economic Development Canada
RSS-210. Operation is subject to the
following two conditions: (1) This
device may not cause harmful inter
-
ference, and (2) This device must
accept any interference that may
be received including interference
that may cause undesired opera
-
tion. WARNING: The transmitter has
been tested and complies with FCC
and ISED rules. Changes or modifi
-
cations not expressly approved by
the party responsible for compliance
could void the user's authority to
operate the device.
This equipment complies with FCC
and ISED radiation exposure limits
set forth for an uncontrolled envi
-
ronment. End Users must follow the
specific operating instructions for
satisfying RF exposure compliance.
This transmitter must be at least 20
cm from the user and must not be
co-located or operating in conjunc
-
tion with any other antenna or
transmitter.
FCC (tats-Unis) et ISED (Canada)
Cet appareil est conforme aux
rglements de la FCC, section 15, et
au CNR-210 d'Innovation, Sciences
et Dveloppement conomique Can
-
ada. Le fonctionnement est assu
-
jetti aux deux conditions suivantes:
(1) cet appareil ne doit pas causer
d'interfrences nuisibles et (2) cet
appareil doit accepter toute inter
-
frence reue, y compris celle qui
pourrait entraner un dys
-
fonctionnement. MISE EN GARDE:
L'metteur a subi des tests et est
conforme aux rglements de la FCC
et d'ISDE. Les changements ou
modifications non approuvs explic
-
itement par la partie responsable de
la conformit pourraient rendre
caduque l'autorisation de l'utilisa
-
teur de se servir du dispositif.
Cet appareil est conforme aux lim
-
ites d'exposition aux radiations de la
FCC et d'ISDE tablies pour un envi
-
ronnement non contrl. Les utilisa
-
teurs finaux doivent respecter les
instructions d'utilisation spcifiques
pour satisfaire aux exigences de
conformit aux expositions de RF.
L'metteur doit se trouver 20 cm
au minimum de l'utilisateur et ne
doit pas tre situ au mme endroit
que tout autre metteur ou antenne
ni fonctionner avec un autre met
-
teur ou antenne.