Driving your vehicle
1745
Reverse Parking Collision-Avoidance Assist (PCA)
䳜 The road is slippery or inclined
䳜 The driver backs up the vehicle
immediately after shifting to R
(Reverse)
䳜 The driver accelerates or circles
the vehicle
Reverse Parking Collision-Avoidance
Assist may unnecessarily warn the
driver or assist with braking even if
there are no pedestrians or objects
under the following circumstances:
䳜 Any non-factory equipment or
accessory is installed
䳜 Your vehicle is unstable due to an
accident or other causes
䳜 Bumper height or rear ultrasonic
sensor installation has been mod
-
ified
䳜 Your vehicle height is low or high
due to heavy loads, abnormal tire
pressure, etc.
䳜 Rear view camera or the rear
ultrasonic sensor(s) is stained
with foreign matter, such as
snow, dirt, etc.
䳜 The pattern on the road is mis
-
taken for a pedestrian
䳜 There is shadow or light reflecting
on the ground
䳜 Pedestrians or objects are around
the path of the vehicle
䳜 Objects generating excessive
noise, such as vehicle horns, loud
motorcycle engines or truck air
brakes, are near your vehicle
䳜 Your vehicle is backing towards a
narrow passage or parking space
䳜 Your vehicle is backing towards an
uneven road surface, such as an
unpaved road, gravel, bump, gra
-
dient, etc.
䳜 A trailer or carrier is installed on
the rear of your vehicle
䳜 An ultrasonic sensor with similar
frequency is near your vehicle
䳜 Always pay extreme caution while
driving. The driver is responsible
for controlling the brake for safe
driving.
䳜 Always pay attention to road and
traffic conditions while driving,
whether or not there is a warning.
䳜 Always look around your vehicle
to make sure there are no pedes
-
trians or objects before moving
the vehicle.
䳜 The performance of Reverse
Parking Collision-Avoidance Assist
may vary under certain condi
-
tions.
If vehicle speed is above 2 mph (4
km/h), the system will provide
collision avoidance assist only
when pedestrians are detected.
Always look around and pay
attention when backing up your
vehicle.
䳜 Some objects may not be
detected by the rear ultrasonic
sensors due to the objects dis
-
tance, size or material, all of
To Next Page
Loading...
