P/N 06-236530-001 3-33 August 2013
3-2.5.2.4.3 How to Set the Display to Show the Standby-Battery Condition
Purpose: To replace the "System Status Normal" message on the
display with the standby-battery charging voltage and current. The
display will have the following typical appearance:
3-2.5.2.4.4 How to Set the Display to Not Show the Standby-Battery Condition
Purpose: To replace the standby-battery charging voltage and current
with the "System Status Normal" message on the display.
Step Action Result
1 Press 0 Key Initiate menu access
2 Enter Password; Press “Enter” Key Gain access to menus
3 Press 3 Key Enter Set-Menu branch
4 Press 1 Key Access "Time / Date" option
5 Press 1 Key Enable battery-charging display
6 Press "Backspace" Key (as required) Exit Menu System
Step Action Result
1 Press 0 Key Initiate menu access
2 Enter Password; Press “Enter” Key Gain access to menus
3 Press 3 Key Enter Set-Menu branch
4 Press 9 Key Access "Battery" option
5 Press 2 Key Disable battery-charging display
6 Press "Backspace" Key (as required) Exit Menu System
PS: 25.5 V 1 mA 02:15 PM 07/02/04
North Communications Center
To Next Page
Loading...
