Chapter 2: Front panel programming
90 P/N 3102352-EN • REV 005 • ISS 28DEC18
For the FX-1000 panel, addresses 1 to 125 are detectors and addresses 201 to 325 are
modules.
Note: The device label occupies two lines just below the device number.
6. Program each device in the system using Table 28 on page 87.
Note: If you chose a dual address device, both addresses for the device are displayed on
the screen (e.g., 001/002). The first address listed is the device address you are
programming. When you pick the second address to program, both addresses are still
displayed but the order is reversed (e.g., 002/001).
Note: Depending on the type of device you are programming, some of the options in the
table below may not be available.
7. When you finish programming an option, choose Save, then choose the next option.
8. Press the Menu button to exit menu mode, or continue programming.
Programming relay and sounder detector bases
Relay and sounder bases require some configuration not required by other devices. First, the
panel does not automatically distinguish between relay and sounder bases — Both are set by
default to base type “relay.” You must manually change this setting for sounder bases.
In addition, configuration is required to control how these devices are activated. Relay bases
can be activated by:
• The detector to which they are attached
• One or more correlation groups
Sounder bases can be activated by:
• The detector to which they are attached
• One or more correlation groups
• The 24 volt riser
You can configure these options using the procedure given below. See Table 28 on page 87
for information on the Base and Follow options.
To change the relay/sounder base type and follow option:
1. Press the Menu button, and then choose Programming.
2. Choose Advanced Program and enter the level 2 password.
3. Choose Loop Configuration and select the loop number. (This option is displayed only if the
panel has multiple loops.)
4. Choose Devices, and then enter the number of the device to be programmed. The serial
number of the device is displayed.
5. Press the Enter button.
To Next Page
Loading...
