Kidde FX-64 - Changing the Passwords; Sample Values for Daylight Saving Time

Chapter 2: Front panel programming
58 P/N 3102352-EN • REV 005 • ISS 28DEC18
8. Set the Week End. (Values range from 1 to 5, where 5 corresponds to the last week of the
month.)
9. Set the Weekday Start. (Values range from 1 to 7, where 1 corresponds to Sunday.)
10. Set the Weekday End.
11. Set the Hour Start. (Values range from 00 to 23, where 00 corresponds to 12 midnight.)
12. Set the Hour End. (Values range from 00 to 23.)
13. Set the Minutes Offset. (Values range from 0 to 255.). This controls the number of minutes
the clock will adjust when daylight saving time begins and ends. The default is 60 minutes.
14. Press Enter, and then choose Save.
15. Press the Menu button to exit menu mode, or continue programming.
Sample values for daylight saving time
The values in the following table:
• Start daylight saving time at 2:00 a.m. on Sunday, the second week of March
• Return to standard time at 2:00 a.m. on Sunday, the first week in November
• Adjust the time by 60 minutes (1 hour) each time
Table 20: Sample values for daylight saving time
Month start:
Week start:
Week day start:
Hour start:
March
Second
Sunday
2
Month end:
Week end:
Week day end:
Hour end:
November
First
Sunday
2
Adjustment
minutes: 60
Changing the passwords
The second step in programming the panel is to change the level one, level two, and remote
annunciator passwords.
Notes
• We recommend that you change the default passwords before programming the system.