Chapter 3: System operation
132 P/N 3102352-EN • REV 005 • ISS 28DEC18
Used for manual evacuation in the Canadian Marketplace. Pressing the Alarm ON button
places the control panel in the alarm condition, activates all drillable outputs which include all
notification appliance circuits and all sounder bases,
signals the central station with CID 115.
The panel still responds to initiating device circuits that are activated while sounding a
manual evacuation. The Alarm ON event is restored upon panel reset. If Alarm ON is
initiated while reset is in progress, the event will be restored at the end of reset.
To meet CAN/ULC-S527requirements, User Key 1 default is Alarm ON when the Canadian
marketplace is selected.
Programmable button function priority
• Operations such as Signal Silence, Auto Signal Silence, and Drill take priority over Activate,
Restore, and Disable.
• Activate, Restore, and Disable take priority over in-suite signal silence.
• A single Restore or Disable takes priority over one or more Activates.
• Restore or Group Disable only affects devices from correlation groups that have been
added to the list for that button.
• Although an Activate button can turn on both latched and unlatched devices, it can only
turn off unlatched devices. Latched outputs remain active until you press a button
programmed for Unlatch. Until the output has been unlatched, the panel displays an
“Outputs are Latched” monitor event message.
• The Disable and Restore commands do not affect active latched outputs until after the
Unlatch button has been pressed. Until the output has been unlatched, the panel displays
an “Outputs are Latched” monitor event message.
To Next Page
Loading...
Need help?
General
