7.4 Electrical installation
Carry out the electrical connection and installation in accordance with
VDE regulations (DIN VDE 0100 and DIN VDE 0116), local regulations
and the technical connection requirements laid down by your electricity
supply company.
■ DIN VDE 0100: Installation of HV systems with rated voltages up to
1000 V
■ DIN VDE 0116: Electrical equipment for combustion systems
7.5 Operating instructions
According to EN 12828, section 5 and EN 12170/12171, the system
installer must produce operating instructions for the whole system.
7.6 Flue system
Only flue pipes that meet Building Regulations may be used with con-
densing systems.
7.7 Checks as part of the Building Regulations approval process
As part of the Building Regulations approval process, condensing
combustion equipment is tested by the flue gas inspector (where appli-
cable) for adherence to Building Regulations and any general recog-
nised technical rules to be observed.
The State Building Regulations, their implementation orders and the
combustion equipment ordinances, as well as the general building
approvals and permits of the higher supervisory authority, in individual
cases, are part of the Building Regulations requirements.
Appendix
(cont.)
92
PYROT
7
5822 516 GB
To Next Page
Loading...