KONE NanoSpace™
Owner’s Manual
104 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
27 Check the length and the level of the
grip marks on both sides.
The marks must be approximately on the
same level.
Otherwise the safety gears must be
adjusted. If the
safety gear does not stop
the elevator immediately, the safety
gears must be replaced.
28 Remove the safety gear marks using a
file.
Removing the marks avoids excessive
wear of guide shoes and roller
guides.
29 Drive on inspection to a suitable level
for going to the landing.
W
ARNING! Be extremely careful when
driving upwards on inspection.
30 Go to the landing. 1. Slowly open the landing door so that
no one steps in
from the landing
thinking that the elevator car has
arrived.
2. Check that no one can enter the shaft
from the landing.
3. Go to the landing.
4. Lower down the optional car top
safety buf
fers, if applicable.
5. Switch off the inspection drive.
6. Release the stop switch.
7. Close the landing doors.
8. Check that the landing door is
mechanica
lly locked.
9. Go to the MAP.
10. If applicable, reset the shaft access
monitor (SAM). Refer to
: APPENDIX
B.1. (Page 162.)
31 Make notes of the test. After completing all tests, record the test
date and
all results in the elevator’s log
book at once.
Step Action Illustration/Note
To Next Page
Loading...