Kone NanoSpace - Page 59

KONE NanoSpace™
Owner’s Manual
58 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
8.3.4 Checking overspeed contact operation
The following table describes the action
s you must perform to check the overspeed contact
operation in OL35.
7 mm 3.5 mm
8 mm 2.5 mm
Step Action Illustration/Note
1 Turn the contact plate so that the knob
of the overspe
ed contact is not in the
notch of the contact plate.
2 Check that overspeed contact cuts the
safety chain.
Ele
vator must not drive in normal or
inspection drive mode.
NOTE! RDF bypasses the overspeed
contact.
Groove type Rope diameter (d) Maximum dimension (T)
T
d
1008983.wmf
1009006.wmf