KONE NanoSpace™
Owner’s Manual
83 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
6 Reset the pit safety device. Refer to APPENDIX B.2 Resetting pit
safety device.
7 Switch off the Recall Drive Feature
(RDF). (POS 270.)
The elevator car must not
move.
The pit ladder safety
switch must prevent the
relevel
ling drive.
8 Close and lock the maintenance access
panel.
9 Op
en the bottom floor landing door by
using em
ergency opening key.
10 Set the pit ladders to normal position.
11 Close the landing doors. Check that the landing door is
mechanically locked.
12 Go to the maintenance access panel
(MAP).
13 Switch on the Recall Drive Feature
(RDF). (POS 270.)
14 Reset the Shaft Access Monitor (SAM),
if a
pplicab
le.
Refer to APPENDIX B.1 Resetting the
shaft access monitor (SAM).
15 Reset the pit safety device. Refer to APPENDIX B.2 Resetting pit
safety device.
16 Switch
off the Recall Drive Feature
(RDF). (POS 270.)
NOTE! The el
evator starts the relevelling
drive.
17 Make notes of the test. After completing all tests, record the test
date
and all results in the elevator’s log
book at once.
Step Action Illustration/Note
1083922.wmf
To Next Page
Loading...