Kone NanoSpace - Page 95

KONE NanoSpace™
Owner’s Manual
94 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
10.7.2 Testing the buffers on the car roof
NOTE! For using the car top buffers, see APPENDIX C.
22 Close and lock the maintenance access
panel (MAP).
23 Go
to the pit. See steps 4 – 10.
24 Check that the car buffers and car sling
buffer plates are in
good condition.
Polyurethane buffers: check that there
are no cracks or powdering.
25 Go to the landing. See steps 12 – 15.
26 Make notes of the test. After completing all tests, record the test
date
and all results in the elevator’s log
book at once.
Step Action Note
1 Go to the maintenance access panel
(MAP).
2 Check that the Recall Drive Feature
(RDF) is on.
POS 270.
3 Reset the Shaft Access Monitor (SAM),
if applicab
le. Related information: APPENDIX B.
Resetting the safety devices.
4 Reset the pit safety device.
Step Action Note
1072612.wmf