KONE NanoSpace™
Owner’s Manual
97 (196) OM-01.03.086
(B) 2016-01-11
© 2014 KONE Corporation
All rights reserved.
15 Go to the landing. 1. Slowly open the landing door so that
no one steps in from the landing
thinking that the elevator car has
arrived.
2. Check that no one can enter the shaft
from the landing.
3. Go to the landing.
4. Release the stop switch.
5. Switch off the inspection drive.
6. Close the landing doors.
7. Check that the landing door is
mechan
ically locked.
16 Reset the Shaft Access Monitor (SAM),
if applicab
le.
Related information: APPENDIX B.
Resetting the safety devices.
17 Make a landing call to the topmost floor.
18 Go to the maintenance access panel
(MAP).
Use the elevator.
19 Disable the landing calls.
LCEUI switch 261.
20 Disable the door opening.
LCEUI switch 263.
21 Make a car call to the topmost floor
from the main
tenance access p
anel
(MAP).
22 Switch on the Recall Drive Feature
(RDF).
POS 270.
Step Action Note
1085428.wmf
To Next Page
Loading...