PAGE 17 - EDIT: QUANTIZE
The quantize function corrects any rhythm error after
recording.
After setting the various parameters, press ENTER to execute.
The “Are you sure?” message will appear. Press ENTER to
confirm, EXIT to abort.
Trk (Track)
Use this parameter to select a track.
All All tracks selected.
1…16 Selected track.
Resol (Resolution)
This parameter sets the quantization after recording. For
example, when you select 1/8a, all notes are moved to the
nearest 1/8 division. When you select 1/4, all notes are moved
to the nearest 1/4 division.
(1/32)… (1/4)
Grid resolution, in musical values. An “a” after
the value means no swing. A “b…f” after the
value means swing-quantization.
S / E (Start/End)
Use these parameters to set the starting (S) and ending (E)
points of the range to quantize.
If you wish to select a four-measure sequence starting at the
beginning of the Song, the Start will be positioned at
1.01.000, and the End at 5.01.000.
Bottom / Top
Use these parameters to set the bottom and top of the key-
board range to quantize. If you select the same note as the
Bottom and Top parameters, you can select a single percus-
sive instrument in a Drum track.
Note: These parameters are available only when a Drum track
is selected.
PAGE 18 - EDIT: TRANSPOSE
Here you can transpose the Song, a track or a part of a track.
After setting the various parameters, press ENTER to execute.
The “Are you sure?” message will appear. Press ENTER to
confirm, EXIT to abort.
Trk (Track)
Use this parameter to select a track.
All All tracks selected (apart for Drum tracks).
1…16 Selected track.
Value
Value of the transpose (in semitones).
S / E (Start/End)
Use these parameters to set the starting (S) and ending (E)
points of the range to transpose.
If you wish to select a four-measure sequence starting at the
beginning of the Song, the Start will be positioned at
1.01.000, and the End at 5.01.000.
Bottom / Top
Use these parameters to set the bottom and top of the key-
board range to transpose. If you select the same note as the
Bottom and Top parameters, you can select a single percus-
sive instrument in a Drum track.
PAGE 19 - EDIT: VELOCITY
Here you can change the Velocity value for the notes.
After setting the various parameters, press ENTER to execute.
The “Are you sure?” message will appear. Press ENTER to
confirm, EXIT to abort.
Trk (Track)
Use this parameter to select a track.
All All tracks selected.
1…16 Selected track.
Value
Velocity change value.
S / E (Start/End)
Use these parameters to set the starting (S) and ending (E)
points of the range to edit.
Trk:1
Resol:
S001.01.000 E001.01.192
Bottom:C-1 Top: G9
Edit:Quantize
No quanti-
zation
1/8
1/4
Trk:1
Value: +0
S001-01-000 E001-01-192
Bottom:G-1 Top:C8
Edit:Transpose
Trk:1
Value: +0
S001-01-000 E001-01-192
Bottom:G-1 Top:C8
Edit:Velocity
To Next Page
Loading...
Need help?
General
