10. Restoring the factory preset sounds
25
STEP 2
10. Restoring the factory preset sounds
The factory preset sounds are referred to as the “pre-loaded” data. Here’s how to load the pre-
loaded data.
1 On the TRINITY V3, TRINITY V3 pro, or TRINITY V3 proX, insert the included “TFD-00P-V3” floppy
disk into the disk drive. On the TRINITY, insert the included “TFD-00P” into the disk drive.
For details refer to “8. Disk mode” (☞page 53 in this manual).
2 Press the [DISK] key.
You will enter Disk mode.
3 Press the first tab button.
The Load display will show file information.
4 On the TRINITY V3, TRINITY V3 pro, or TRINITY V3 proX, select “V3_PLOAD.PCG.” On the TRINITY,
select “PRELOAD1.PCG.”
The display will be inverted.
These .PCG files contain program, combination, and global data.
5 Press the page menu button.
The page menu commands will appear.
6 Press the Load Selected page menu command.
A dialog box will appear.
7 If you wish to load the .SNG file (demo playback data) at the same time, press the check box to
check it.
If this box is checked, the .SNG file of the same name as the .PCG file will be loaded as well.
When a .PCG or .SNG file is loaded, the programs, combinations, and global data, and song
data that is currently in memory will be rewritten.
If you want to preserve the program, combination, global, and song data, save it to a floppy
disk (☞page 56 in this manual).
8 Press the OK button.
PostScript error (undef
To Next Page
Loading...
