3. Combination Play mode
36
3. Combination Play mode
Press the front panel [COMBI] key to enter this mode. When the power is turned on, this mode
will automatically be selected.
Here you can select combinations, and specify the program, pan, and volume setting for each tim-
bre of the combination.
To save a combination that you have edited, turn off the memory protect setting in Global mode
(☞page 51 in this manual) and write the combination into memory (☞page 23 in this manual).
Selecting a combination
A combination can be selected in the three ways listed below. For the procedure, refer to the page
given.
The combinations that can be selected will depend on whether the Playback Sampler/flash ROM
option is installed (☞page 9 in this manual).
For the factory preset combination names, refer to the separate Voice Name List booklet.
• A combination can be selected from the front panel (☞page 15 in this manual)
• A combination can be selected by a connected assignable switch (☞page 16 in this manual)
• A combination can be selected by an incoming MIDI Program Change message (☞page 62 in
this manual)
Ways to select the program for each timbre
There are two ways to select the timbre program (the program used by each timbre) in the combi-
nation.
The programs that can be selected will depend on the model that you have, and on whether the
Playback Sampler/flash ROM option and/or the MOSS-TRI option has been installed (☞page 9 in
this manual).
For the factory preset program names, refer to the separate Voice Name List booklet.
• A program can be selected from the front panel (☞page 9 in this manual)
• A program can be selected by an incoming MIDI Program Change message (☞page 62 in this
manual)
Selecting the timbre program on the unit
1 Press the Bank button for a timbre.
The display will be inverted.
2 Use the [▲]/[▼] keys to select the bank.
You can select the bank using VALUE controllers
other than the numeric keys and ENTER.
3 Press program of the same timbre.
The display will be inverted.
4 Use the VALUE controllers to select the program.
The program used by a timbre can also be selected
in Combination Edit mode P1, tab page 1 (Combi
Basic).
1
3
To Next Page
Loading...
Need help?
General
