Disk Mode Enhancements in Version 3
Macros
4-49
does not need to be explicitly selected with the Select soft button.) You can use the following
double-presses to select and deselect all entries in the list:
• Left/Right cursor double-press: Select all macro entries
• Up/Down cursor double-press: Clear all selections
With all the entries selected, our display looks like this:
Func:MACRO|[Record]||||||||||Index:|||1|
||||||||||||||||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
*4:\NEWMIX\TRASHX12.KRZ||||||||200:F:|||
*4:\POTS\TEAPOT.KRZ||||||||||||300:F:|||
*4:\PANS\FRYING.KRZ||||||||||||400:F:|||
*4:\KITCHEN\SINK.KRZ|||||||||||500:F:Obj
Select|Modify||Load||Pause|||Off|||Exit|
Two soft buttons have yet to be explained. They are Modify and Load.
Press the Modify soft button to change any items mentioned at the top of this section. You will
see the following display:
Modify|Macro|Entries||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Modify:Drive||||||||||||||||||||||||||||
Drive|:SCSI|4|||||||||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
4|entries|selected.|||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Delete||OK|||Cancel
This shows the screen that allows you to change the SCSI drive for the selected macro entries. If
you increment the Modify parameter, the display switches to let you modify Bank and Mode
information:
Modify|Macro|Entries||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
Modify:Bank/Mode||||||||||||||||||||||||
Bank||:200's||||||Mode:Fill|||||||||||||
||||||||||||||||||||||||||||||||||||||||
4|entries|selected.|||||||||||||||||||||
||||||||||||||||||||||||||||||||||||||||
|||||||||||||||||||||Delete||OK|||Cancel
The initial settings of the parameters on these screens are always taken from the lowest indexed
macro entry that is selected on the MACRO page. In addition, every time you return to the
Modify Macro Entries page, both the Modify parameter and the cursored parameter field will be
the same.