Using Various Functions > Job Finish Notice
166
Job Finish Notice
Sends E-mail notice when a job is complete.
It can also be set up to send a notice when a job is interrupted.
Users can be notified of the completion of a job while working at a remote desk, saving the time spent waiting
beside the machine to finish.
NOTE
• PC should be configured in advance so that E-mail can be used. For details, refer to the following:
➡ Command Center RX (page 78)
• E-mail can be sent to a single destination.
Item Description
[Off] Disables the function.
[Finished only] Enter E-mail address directly. Enter the E-mail address (up to 128
characters) and select the [OK] Key.
[Fin.+Interrupted] Enter E-mail address directly. Enter the E-mail address (up to 128
characters) and select the [OK] Key.
To Next Page
Loading...
