System Menu > Device Common
229
Timer Setting
[Menu] key > [ ] [ ] key > [Device Common] > [OK] key > [ ] [ ] key > [Timer Setting] > [OK] key
[Auto Panel Reset]
If no jobs are run for a certain period of time, automatically reset settings and return to the default setting. Select
to use Auto Panel Reset or not.
Value: [Off], [On]
NOTE
For setting the time until the panel is automatically reset, refer to the following:
➡ PanelReset Timer (page 229)
[PanelReset Timer]
If you select On for Auto Panel Reset, you can set the amount of time to wait before Auto Panel Reset.
Value: 5 to 495 seconds (in 5 second increments)
NOTE
This function is displayed when [Auto Panel Reset] is set to [On].
[Sleep Level Set.]
Select the sleep level.
This function will not be displayed when the optional Network Interface Kit or Fiery controller is installed.
[Sleep Timer]
Set amount of time before entering Sleep.
Value: 1 to 120 minutes (1 minute increments)
➡ Sleep (page 57)
Item Description
[Status] Select whether to use Energy Saver for the following functions
individually:
• ID Card Reader
Displayed when the optional Card Authentication Kit is activated.
• Application Startup
Value: [On], [On]
NOTE
When the machine has entered sleep mode with Energy Saver setting, the
ID card cannot be recognized.
To Next Page
Loading...
