Installing and Setting up the Machine > Command Center RX
78
Command Center RX
If the machine is connected to the network, you can configure various settings using Command Center RX. This
section explains how to access Command Center RX, and how to change security settings and the host name.
➡ Command Center RX User Guide
NOTE
To fully access the features of the Command Center RX pages, you must enter the user name and password and
log in. Entering the predefined administrator password allows the user to access all pages, including document
box and settings on the navigation menu.
Settings that the administrator and general users can configure in Command Center RX are as follows.
Accessing Command Center RX
1
Display the screen.
1 Launch your Web browser.
2 In the address or location bar, enter the machine's IP address or the host name.
Click in the following order to check the machine's IP address and the host name.
In the home screen [Status] > [ ][ ] key > [Network] > [OK] key[]
Example: https://10.180.81.1 (in the case of /IP address)
https://MFP001 (if the host name is MFP001)
Setting Description Administrator General User
Device Information/
Remote Operation
The machine's structure can be checked. Yes Yes
Job Status Displays all device information, including print
and scan jobs, storing jobs, scheduled jobs, and
job log history.
Yes Yes
Document Box Add or delete document boxes, or delete
documents within a document box.
The logged in user may not be able to configure
some settings, depending on the privilege of the
user.
Yes Yes
Device Settings Configure the advanced settings of the machine. Yes No
Function Settings Configure the advanced function settings. Yes No
Network Settings Configure the network advanced settings. Yes No
Security Settings Configure the security advanced settings. Yes No
Management Settings Configure the advanced management settings. Yes No
To Next Page
Loading...
Need help?
General
Weight and Dimensions
