Installing and Setting up the Machine > Default Settings of the Machine
57
Energy Saver function
If a certain period of time elapses after the machine is last used, the machine automatically enters Sleep to
minimize power consumption.
Sleep
Panel and all indicators on the operation panel will go out to save a maximum amount of power except the Energy
Saver indicator. This status is referred to as Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing.
In addition, the machine wakes up when the following operations are performed:
• Select the [Energy Saver] key.
Recovery time from Sleep Mode is as follows.
6.0 seconds or less
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Function that automatically switches the machine into Sleep if left idle for a preset time. Switch time has a factory
default of 1 minute.
When using this machine, select the [Energy Saver] key.
You will be able to use again within 6 seconds.
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
The procedure for specifying the switch time for the sleep function is explained below.
1
Display the screen
[Menu] key > [ ][ ] key > [Device Common] > [OK] key > [ ][ ] key > [Timer Setting] > [OK] key >
[ ][ ] key > [Sleep Timer] > [OK] key
To Next Page
Loading...
