System Menu > Security
241
CAUTION
Job box data saved in applications or SD cards cannot be deleted. If you want to erase this, you need to format the
SD card.
NOTE
• Print [DataSanitization] and check that security data has definitely been erased.
➡ Report (page 185)
• You cannot cancel a process in the middle.
• Disconnect any modular or network cables before performing this operation.
• Before executing this function, set all [I/F Block Set.] to [Unblock].
➡ I/F Block Set. (page 238)
• Do not turn off the power during data sanitization. If the power is turned off during erasing, erasing will be
performed automatically after the power is turned on, but complete operation cannot be guaranteed.
[SW Verification]
Verify the software in the machine.
Select [Start] to run the verification. If you experience any abnormalities in software verification, contact your
service representative.
Manual FW Update
[Menu] key > [ ][ ] key > [Security] > [OK] key > [ ][ ] key > [Manual FW Update] > [OK] key
Item Settings
[Run Immediately] Execute security data sanitization.
[Schedule] The address information and image data in the machine will be
completely erased at the specified time.
Value: [On], [Off]
If you select [On], set the date and time for complete erasure. Value:
Year (2000 to 2035), Month (1 to 12), Day (1 to 31), and Hour (0 to 23).
[Device Use] After data sanitization, the usage of this machine will be restricted.
If [Prohibit] is selected, machine operation is disabled.
Value: [Permit], [Prohibit]
Item Description
[Manual FW Update] Set whether to allow manual firmware updates.
Value: [Not Allowed], [Permit]
To Next Page
Loading...
Need help?
General
Weight and Dimensions
