System Menu > Network
212
ProtocolSettings
[Menu] key > [ ][ ] key > [Network] > [OK] key > [ ][ ] key > [ProtocolSettings] > [OK] key
Configures protocol settings.
[Bonjour]
[IP Filter (IPv4)]
[IP Filter (IPv6)]
[IPSec]
Item Description
[Off/On] Select whether to use Bonjour.
Value: [Off], [On]
[AvailableNetwork] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
Item Description
[Off/On] Configure the IP Filter Setting. IP filter is a function used to restrict the
access to the machine by setting the IP address and protocol.
The IP address or network address of permitted hosts is set from
Command Center RX. Not setting the IP Filter will allow access from all
hosts.
Value: [Off], [On]
➡ Command Center RX User Guide
Item Description
[Off/On] Configure the IP Filter Setting. IP filter is a function used to restrict the
access to the machine by setting the IP address and protocol.
The IP address or network address of permitted hosts is set from
Command Center RX. Not setting the IP Filter will allow access from all
hosts.
Value: [Off], [On]
➡ Command Center RX User Guide
Item Description
[Off/On] Set whether or not to use the IPSec.
Value: [Off], [On]
To Next Page
Loading...
