Appendix > Character Entry Method
384
Entering Symbols
Symbols can be entered.
1
Select the [#] key. Displays the symbol list.
2
Select the [ ][ ][ ][ ] key to move the cursor and select the symbol to be
entered.
3
Select the [OK] key. The selected symbol is entered.
Entering Characters
Follow the steps shown below to enter "R&D" for example.
1
Select the [7] key three times. [r] is entered.
w x y z W X Y Z 9 (Repeats from the first character on the left)
9 (During number entry)
. , - _ ' ! ? (space) 0 (Repeats from the first character on the left)
0 (During number entry)
Select to change the character in the cursor position between upper case and lower
case.
"*" or "." (During number entry)
Input key Characters (Each press of a key changes the character in the order from left to right.)
To Next Page
Loading...
