Installing and Setting up the Machine > Command Center RX
83
SMTP
Set to send e-mail from the machine.
[SMTP Protocol]
Displays the SMTP protocol settings. Check that [SMTP Protocol] is set to [On]. If [Off] is set, click
[Protocols] and set the SMTP protocol to [On].
[SMTP Server Name]
Enter the host name or IP address of the SMTP server. Be sure to enter the items.
[SMTP Port Number]
Specify the port number to be used for SMTP. The default port number is 25.
[SMTP Server Timeout]
Set the amount of time to wait before time-out in seconds.
[Authentication Protocol]
To use SMTP authentication, enter the user information for authentication.
[Connection Test]
Tests to confirm the proper operation under the settings without sending an email.
[Domain Restrictions]
To restrict the domains, click the [Domain List] and enter the domain names of addresses to be allowed
or rejected. Restriction can also be specified by e-mail address.
POP3
You don't need to set the items when you only use the function of sending e-mail from the machine. Set
the items if you want to enable the function of receiving e-mail on the machine.
➡ Command Center RX User Guide
E-mail Send Settings
[E-mail Size Limit]
Enter the maximum size of E-mail that can be sent in kilobytes. When E-mail size is greater than this
value, an error message appears and E-mail sending is canceled. Use this setting if you have set E-mail
Size Limit for SMTP server. If not, enter a value of 0 (zero) to enable E-mail sending regardless of the
size limit.
[Sender Address]
Specify the sender address for when the machine sends E-mails, such as the machine administrator,
so that a reply or non-delivery report will go to a person rather than to the machine. The sender
address must be entered correctly for SMTP authentication. The maximum length of the sender
address is 256 characters. Be sure to enter the items.
[Signature]
Enter the signature. The signature is free form text that will appear at the end of the E-mail body. It is
often used for further identification of the machine. The maximum length of the signature is 512
characters.
[Function Default]
Change the function default settings in [Customize Status Display] page.
5
Click [Submit].