Glossary
Glossary-2
Printer driver
The printer driver makes it possible for you to print data
created using application software. The printer driver for
either the printer is on the
Kyocera Mita Digital Library
CD-
ROM supplied with the printer. Install the printer driver on
the computer connected to the printer.
RAM disk
This is a virtual disk drive that uses part of the printer’s
memory. With the RAM disk you can set any memory size
arbitrarily, and use electronic sorting (to reduce print time).
Simple Network Management Protocol (SNMP)
This is a protocol for the management of networks that use
TCP/IP (Transmission Control Protocol/Internet Protocol).
Sleep mode
This mode is activated after a specified amount of time
elapses. The printer goes into the economy mode and a
minimum amount of power is consumed. You can change the
amount of time before the printer goes into the sleep mode
from the printer’s operator panel. The default setting is 15
minutes.
Status page
This lists printer conditions, such as the printer’s memory,
the total number of copies printed, and paper source settings.
To Next Page
Loading...
