Chapter 1 Using the Operator Panel
1-16
Selecting the Paper Size Unit for the Paper
Cassette
Set the paper size unit as described below when Custom is se-
lected.
When the paper size is set to Custom, press the
key.
>>Unit appears and the unit currently set is dis-
played. You can select either mm or inch. The default
setting is mm.
Press the ENTER key. A blinking question mark (?)
appears.
Press the or key to select mm or inch.
Press the ENTER key.
Entering the Width and Length
Then, use the following procedure to set the paper size when
the paper size is set to Custom.
When the unit of measurement is set, press the
key. >>X Dimension appears (the paper width set-
ting).
Press the ENTER key. A blinking cursor (_) appears.
Press the or key to increase or decrease the
value of the figure where the cursor is blinking and
display the desired width. The width can be set be-
tween 148 and 297 mm (5.83 to 11.69 inches). You
can use the and keys to move the cursor right
and left.
Display the paper width and press the ENTER key.
When the width is set, press the key. >>Y Dimen-
sion appears (the paper length setting).
Press the ENTER key. A blinking cursor (_) appears.
Set the desired length in the same way as you set
the paper width. The length can be set between 210
and 432 mm (8.27 to 17.01 inches).
When the desired paper length is displayed, press
the ENTER key.
Press the MENU key. The message display returns to
Ready.
>Cassette Size >
Custom
>>Unit
mm
>>Unit
? mm
1
2
3
4
5
>>X Dimension
297 mm
>>X Dimension
297
mm
>>Y Dimension
432 mm
>>Y Dimension
432
mm
>>Y Dimension
432 mm
1
2
3
4
5
6
7
8
9
To Next Page
Loading...
